Jump to content

Cobra A8510 immobiliser wiring help.


Recommended Posts

Hi all,

I have just bought a Cobra immobiliser for my 05 STI as it doesnt have any factory security fitted. The key is the non transponder type ( JDM ).

Looking at the wiring instructions provided, they are a bit "wishy washy" to say the least but ive managed to figure out that there are 2 sets of wires marked 1 & 2 that are used to operate the immobiliser circuit relays in the unit. These have a scissors symbol in the instructions so i think that means to cut the wire in the vehicle loom and bridge with the immobiliser loom.

Instructions say to connect to 2 circuits to prevent the car from starting which i,m assuming one is the fuel pump relay, earth feed ?

Secondly, the 12v ignition circuit live under engine cranking?

Does anyone know if this is correct?

My gut feelings are that i should locate the fuel pump relay under the dash and access the earth for the pump here. Then instead of going in behind the ignition switch, i look for the 12v feed to the ECU? In essence, i reroute the 12volt feed to the ECU via the immobiliser relays.

If anyone can advise, id greatly appreciate it as i'm a bit wary of breaking into the circuit for the feed to the ECU ( car is remapped by GR performance ) and loosing the map?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...




Forums


News


Membership