Hey all, im new to the site so appologies if there is a similar post....
I have a 2011 subaru wrx sti, im having problems with water system. I was driving the car and the water pressure pushed through and filled the water reservoir. I thought maybe a dodge thermostat as the heater in the car was blowing cold air, i have drained the coolant, cleaned it, changed the thermostat, refilled it and burpped it.....for hours😂😂😂 so thinking all air bubbles out drove the car the next day and within 10-15 mins the temp gauge shot up but to the first top mark air still cold. So today (4th Feb) i got timeand re burped it using a water botter/filler in the expansion tank bringing it up to heat and blimping the throttle up to 3k rpm again did this for some time bottom pipe became warm again all bubbling stopped thought ok turned it off for 5 mins then repeated to make sure no bubbles then took it a drive again and 10 mins in temp gauge flies up and water fills up reservoir.......im lost is it water pump......cylinder head gasket.....i hope not..... if you believe it is answer with flamingo leg makes it feel less expensive
Any ideas on how to check or suggestions are very much welcome
And sorry for the book ive just written
