Jonny

Hey people, I’ve got an Impreza classic wagon and it’s never boosted correctly, I've put a gauge on it and it’s only boosting at 0.5 bar. I’ve had the inlet manifold off and checked all the pipes, not fun, didn’t find a single split pipe. Any ideas? It also has an annoying hesitation at gentle throttle. Any help would be appreciated to make it go how it should!

Visual checks only then.☹️

I've done numerous smoke tests on the engine but not luck in finding any leaks.

I thought if you had a boost leak you would hear it? Wooshing out?

Used a genuine maf yes. Haven't tried plugs and leads yet, I noticed when I unplugged the oxygen sensor it ran almost perfectly so presumed it was the sensor but no better. There were 2 codes, 24 and 32. 32 would more than likely be from me unplugging the oxy sensor and 24 said idle air control valve? ive erased the codes and going to run it and check again. Thanks guys!

Hi, still new to the site. I've got a classic Impreza wagon v reg. its got an irritating hesitation nearly all the time, but noticibly worse just cruising/commuting. I've changed the air flow meter and oxygen sensor. But it's still happening. Another problem is it's only boosting at 0.4bar and isn't very Impreza like. Any help would be appreciated!

And what's the deal with a decat? As I got given one with the car. Is it a good thing or does it have to be used with a remap? Or can I just stick it on?

Cheers guys! What exactly am I asking for with my pretty standard wagon classic? A remap? An ecu upgrade?

Anyone suggest a reliable tuner in the south west or near? Looking for my first remap.

Ok, slow and painful way it is! Thanks everyone!

Still not sure on what a restrictor pill is. And did a smoke test to see if there were any air leaks and none appeared.

No codes in memory, what's a restrictor pilot? Car is pretty standard apart from piper cross filter and cat back exhaust. I've adjusted the actuator arm as much as I can and that's getting it closer to .7 at times. But don't feel happy doing this. Going to put the actuator arm back as I found it and clean the boost solenoid.

So you're saying boost sensor? Pipes? Something like that?

Any ideas why it's boosting around .5? And would you say it's safe to adjust the boost to around .9 without a remap? Thanks.

Got a guage and its boosting around .4 - .5 bar. Is that Normal boost for a wagon? And what's a safe boost to run? Thanks.