This evening im going to attempt to fit my front mount after 3weeks of it sat in my room collecting dust I think I need to pull my finger out and get it on the car. any tips/advice as I know I have to cut the wing :(

well wish me luck hahaha!!!!

Good luck I'm sure it will go fine. Only tip's I can give is measure it and then again maybe a third time just to be safe puff out the cheeks then attack :D 

Good luck buddy - dont forget your camera ;)

 

as Gambit says measure lots and big deep breath... remember it is easier to cut a little more off after than put a bit back on so err on the side of less :D

Yeah i will be taking loads of pictures to post up and hopefully it all goes smoothly an to plan haha!

Ahh good stuff good luck mate will be keeping my eye out for pics as I'm going to fit one to my car aswell so will need some insight lol

whilst your in there feed a cold air pipe up thru to the filter too.

What a nightmare this is being haha. was working up till midnight and still not even half way into it. they do make them intercooler pipes a snug fit. also had to relocate where dv is and order some extra hoses to do abit of custom work. will post up pics soon :)

Hang in there chum - it will all be worth it in the end!! :)

eeek not a smooth running job then. But I'm sure you got the worst of it out the way :)