Front mount intercooler

[S30TTY]

This evening im going to attempt to fit my front mount after 3weeks of it sat in my room collecting dust I think I need to pull my finger out and get it on the car. any tips/advice as I know I have to cut the wing :(

well wish me luck hahaha!!!!

[Gambit]

Good luck I'm sure it will go fine. Only tip's I can give is measure it and then again maybe a third time just to be safe puff out the cheeks then attack :D 

[Jay762]

Good luck buddy - dont forget your camera ;)

 

as Gambit says measure lots and big deep breath... remember it is easier to cut a little more off after than put a bit back on so err on the side of less :D

[S30TTY]

Yeah i will be taking loads of pictures to post up and hopefully it all goes smoothly an to plan haha!

[davievtec]

Ahh good stuff good luck mate will be keeping my eye out for pics as I'm going to fit one to my car aswell so will need some insight lol

[scottishtaffy]

whilst your in there feed a cold air pipe up thru to the filter too.

[S30TTY]

What a nightmare this is being haha. was working up till midnight and still not even half way into it. they do make them intercooler pipes a snug fit. also had to relocate where dv is and order some extra hoses to do abit of custom work. will post up pics soon :)

[Jay762]

Hang in there chum - it will all be worth it in the end!! :)

[Gambit]

eeek not a smooth running job then. But I'm sure you got the worst of it out the way :)