Frank Posted July 19, 2017 Share Posted July 19, 2017 Hi, so I have a 99 classic wagon and have just put new wheels on but when I corner even at relatively low speeds I get some god awful rubbage from somewhere at the back. What are the likely culprits? The bit of trim from the arch the seal thing has already fallen off but something is still rubbing. Old wheels 205/50/16 new wheels 215/45/17 i didn't think the overall size was much different to be honest hats why it's confusing over what is rubbing. Any help appreciated. Frank. Quote Link to comment Share on other sites More sharing options...
HawkSTI Posted July 19, 2017 Share Posted July 19, 2017 What is the offset of the new wheels? They maybe sticking out further than your old wheels. Your old wheels may have been tucked in just enough to clear the outside arches. The lower profile ratio of the new tyre should offset most of the extra inch in diameter you now have, so I can't see it being due to the size of the new wheels. I would check the offset 👍 Quote Link to comment Share on other sites More sharing options...
Frank Posted July 19, 2017 Author Share Posted July 19, 2017 I have no idea but comparing the two the new ones stick out by quite a bit. The only markings on the wheels are these Quote Link to comment Share on other sites More sharing options...
aucky Posted July 19, 2017 Share Posted July 19, 2017 As@HawkSTI said the off set is wrong.depending hiw far out they are you could roll the arch ,may clear it.if they stick out a lot go with arch flares but thats a lot work.or finally unfortunatly sell the wheels and get some more. Sent from my LG-D855 using Tapatalk 1 Quote Link to comment Share on other sites More sharing options...
HawkSTI Posted July 19, 2017 Share Posted July 19, 2017 If you look on the wheel, somewhere it should have "ET" followed by a number. The lower the number the further the wheel will stick out. You may need to get the arches rolled slightly if the offset of the new wheels is too low. Quote Link to comment Share on other sites More sharing options...
Rps Posted July 19, 2017 Share Posted July 19, 2017 Is it only catching at the top of the arch under heavy cornering or all the time? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.