jmj Posted November 25, 2017 Share Posted November 25, 2017 Hi all, new member from Kent with my first Impreza UK 2000 with 104k miles. Unfortunately it's not running quite right. Apologies for the long post but trying to give as much info as possible. It ran fine at first but in the last week or two it's throwing a CEL on the motorway under load in 4/5th gear. It also went through a stage of low boost around 6psi and on one occasion the boost dropped so quick it threw me forward quite hard, but it's only ever done that once.Tthe car idles fine and doesn't misfire, the CEL codes were 23 MAF and 32 Lambda. I cleaned the MAF and the code hasn't come back but the Lambda code has. Since the MAF clean it boosts up but will either quiver between 12-14psi, or it will gradually drop to about 8psi. I've cleaned the boost solenoid, MAF and have a new set of NGKs ready to go in. I haven't changed the Lambda as I'm reluctant to spend the money on a new one if it's throwing the code because of the decat. Has anyone had a similar problem? Could it still be the old MAF knackered? According to the last owner it's running around 270bhp with the following engine mods: Remap Decat Yellow injectors Aftermarket induction kit Boost gauge Dumpvalve Samco hoses Shortshift FMIC (fitted but not plumbed in yet) Thanks Quote Link to comment Share on other sites More sharing options...
Swino Posted November 25, 2017 Share Posted November 25, 2017 Do you have proof of the map? Sent from my iphone using Tapatalk Quote Link to comment Share on other sites More sharing options...
savage bulldogs Posted November 25, 2017 Share Posted November 25, 2017 What year uk 2000 is it ? Could be a boost leak but proof of the remap would be good , as if mods haven't been "mapped in" it can cause major running issues .Sent from my SM-G930F using Tapatalk Quote Link to comment Share on other sites More sharing options...
jmj Posted November 25, 2017 Author Share Posted November 25, 2017 No, theres no proof. I got the car at a decent price but with barely any paperwork. Is there an easy way to tell? Quote Link to comment Share on other sites More sharing options...
savage bulldogs Posted November 25, 2017 Share Posted November 25, 2017 It depends on what version it is , version 5 (98 0nwards ish) can have the standard ecu remapped with ecutek software . So the ecu will look stock inside .Pre late 98 have to have a daughter board soldered in or replacement aftermarket ecu to allow them to be re mappedSent from my SM-G930F using Tapatalk Quote Link to comment Share on other sites More sharing options...
jmj Posted November 26, 2017 Author Share Posted November 26, 2017 It's a year 2000 so guessing there's no easy way to tell. I've booked it in at a specialist now so I will see what they come up with. Quote Link to comment Share on other sites More sharing options...
jmj Posted December 2, 2017 Author Share Posted December 2, 2017 Just an update for anyone with similar issues - had a smoke test done and the dump valve was leaking. Had FMIC plumbed in and a new DV, it now holds boost and runs much better. Still getting the odd code for Lambda sensor but assuming this is the decat. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.