New member proud but confused

[Cromity1]

Recently purchased a WRX sti 320r and I love it. It's my first Subaru and a bit of a step up in performance from my old Dicovery 3 which served me well for 9 years.

however the WRX has a zunsport front bumper which my drive does not like and this morning managed to snap the lowest part of the bumper assembly. Can these parts be replaced/removed without causing much stress?

should I also go for a factory front bumper replacement or find a new zunsport part? I have already told the missus we need to move because the drive damaged the car! 

Help and guidance appreciated.

[stants]

Hello & welcome !

Ah not good about the drive situation I presume the splitter just clips on in various places

Sent from my SM-G930F using Tapatalk

[Cromity1]

Looks like they are push pin connectors but will have to jack the car up tonight to have a look and either remove what's left or try and clip it for now. What I don't want to do is damage the bumper if I can help it. 

[Jay762]

Wotcha and welcome - my splitter was all push pin connections - shouldn't be too much of an issue to remove

[Cromity1]

Thanks Jay762, most of them are pushpins but there's about 6 screw/washers as well. Sadly when the splitter ground out it snapped the bumper around two of the screws where a pushpin would have popped out. I've managed to put a temporary fix in to hold the splitter in place until I can fix the drive, get a new bumper and splitter and then get it repaired. 

Also worked out that if I revers off the drive it doesn't ground! Doh!