Ordinaryblazin Posted August 4, 2016 Share Posted August 4, 2016 HELP!! Ok so yesterday all if a sudden the horn,heater fan,front fog lights and my break lights all stopped working I've checked the fuses and they are all fine does anyone have any ideas of what's wrong and how I can fix this it's really confusing and irritating me now please help Quote Link to comment Share on other sites More sharing options...
savage bulldogs Posted August 4, 2016 Share Posted August 4, 2016 If it's a classic did you check both fuse boxes ? , cos it sounds like either a fuse or earth fault If it's not broke .....upgrade it 😊 1 Quote Link to comment Share on other sites More sharing options...
stants Posted August 4, 2016 Share Posted August 4, 2016 Which fuses did you check ?under the dash or main box in engine bay? Sent from my SM-G930F using Tapatalk 1 Quote Link to comment Share on other sites More sharing options...
Ordinaryblazin Posted August 4, 2016 Author Share Posted August 4, 2016 I've check both fuse boxes mate every one of them is fine it's really doin my head in Quote Link to comment Share on other sites More sharing options...
stants Posted August 4, 2016 Share Posted August 4, 2016 Haha must have posted at same time Clive! I had the same thing with rear lights, it turned out to be a fuse but obviously not helping much, I'll rack my brains. Sent from my SM-G930F using Tapatalk Quote Link to comment Share on other sites More sharing options...
Ordinaryblazin Posted August 4, 2016 Author Share Posted August 4, 2016 Thanks stants I've even disconnected the entire fuse box to clean the terminals they wer a little corroded but not that bad really so cleaned them and reconnected still nothing the heaters still blow hot air and can change to cold and were it comes from just no control of the power of it Quote Link to comment Share on other sites More sharing options...
savage bulldogs Posted August 4, 2016 Share Posted August 4, 2016 I'm not too hot on sparky stuff tbh but the loom runs under the rad at the front of the car and if it's not "clipped" to the lower valance it can melt on the headers . So maybe check that area of the loom is ok and the earth's are making a good contact? If it's not broke .....upgrade it 😊 Quote Link to comment Share on other sites More sharing options...
Ordinaryblazin Posted August 4, 2016 Author Share Posted August 4, 2016 Nice one savage il go check that Quote Link to comment Share on other sites More sharing options...
Mark D Posted August 10, 2016 Share Posted August 10, 2016 My heater doesn't work on the low powers, only on full, saw somewhere there is a resistor in the wiring that controls that. Managed to get the fan spinning on low though if I jiggle the wires connecting to the fan :) Sent from my iphone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.