Jump to content

Problem when upgraded rear brakes on 2002 wrx


Ian35
 Share

Recommended Posts

Hi,

I have a 2002 wrx and recently put Brembo breaks onto the rear of my car and replaced the rear discs for bigger ones. They fitted fine no problem, bled the brakes but went on a test run and noticed my abs light is on!!!!

Also my hand brake is none existent I was wondering if I would need sti hub and or hand brake shoes and hand brake parts (don't know if they are bigger)???

Thanks for any help or advice

Link to comment
Share on other sites

Hi mate welcome to S.O.C 

I've seen people do the Brembo upgrades and not had to do that before so shouldn't need to. I would give the contacts a bit of a clean on the ABS sensor and have a play around with it as long as it's not damaged should go away. It was definitely Pads and discs made to fit the Brembo brakes ? 

 

You could also try adjust the Pop out the rubber cap. Use a screwdriver to rotate the adjustment wheel and try to adjust the same amount on each side. You will have to experiment with which way to rotate the adjustment wheel. Do a small amount and pull up the hand brake to see if the brake catches. Repeat until the lever pulls up nicely.

If you can't get enough adjustment that way, you will have to adjust the cable at the lever. Hope that helps :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share






×
×
  • Create New...




Forums


News


Membership


  • Insurance
  • Unread Content
  • Support