Scoobyghost Posted August 12, 2015 Share Posted August 12, 2015 If you've got long nose pliers pinch a bit of kitchen roll or a good absorbant cloth and get that in there to try and dab/clean. Quote Link to comment Share on other sites More sharing options...
martyc Posted August 12, 2015 Author Share Posted August 12, 2015 Tried the screwdriver wrapped in a tea towel method, but couldn't actually get into the bit I needed to. Will try needle nose see it it works any better! Sent from my iphone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Scoobyghost Posted August 12, 2015 Share Posted August 12, 2015 Which bit you getting too? The time spent trying to squeeze in you could probably whip it off [emoji2] Quote Link to comment Share on other sites More sharing options...
martyc Posted August 12, 2015 Author Share Posted August 12, 2015 The rear of the cone fitting that goes into the adaptor into the block. That means stripping out the alt etc again which in itself isn't hard but just time consuming. And I know if I do that I'll end up taking all the t piece line apart and starting from scratch. If it's already there and oil tight I don't want to mess more than I have to! Sent from my iphone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.