April 17, 20169 yr Guys, I have noticed that my check engine light comes on and goes off when warm, after around 45 mins etc. Sometime it stays on, sometimes not. I've plugged the green clips together to try and diagnose but no codes come up, the light is off and doesn't flash or anything? what do you think? James
April 17, 20169 yr Author No mate... What's the correct procedure then? Sent from my SM-G800F using Tapatalk
April 17, 20169 yr Black connectors together under the dash then turn ignition to the 1st position the check engine light should start to flash out the codes (if any)
April 17, 20169 yr Author Thanks, I'll try that tomorrow, may as well get it sorted whilst I have a months labour warranty!
April 17, 20169 yr Author Long flash, long flash followed by two short flashes....I presume that means 22.
April 17, 20169 yr Knock sensor fault, meaning it's not working properly, Mines just done the same thing in the last couple of months, the sensors get brittle over time and crack as they sit on top of the engine block, Simple but fiddly to replace cost about 60 quid for genuine part
April 17, 20169 yr Author Ah OK great.... Wont be a big issue then...do I need to get this done immediately? Sent from my SM-G800F using Tapatalk
April 17, 20169 yr You should do. Mines been randomly throwing up that code for over a year. Shhh don't tell anyone 😋
April 18, 20169 yr No. It hasn't came on for a while but it was more prone to come on at cold start through the winter. It came on roughly 4 times over winter months. Stays on for 2-3 seconds then goes off. Don't risk it, the biscuits are usually quite stale anyway 😖😏
April 18, 20169 yr Does yours come up after you've been driving a while..when engine is hot? Yes mate, mine had a sudden loss of power flashed on and then went away, all was fine, this was after 45 mins of heavy stop start traffic
April 18, 20169 yr Author I'll get it swapped whilst the garage I bought it from are doing the fitting for free. Sent from my SM-G800F using Tapatalk
April 18, 20169 yr Author My worry was will it get me to japest and back on Sunday! Sent from my SM-G800F using Tapatalk
May 12, 20169 yr Author So guys, any ideas here.....Had a new knock sensor fitted recently, all good. No more check engine light on trip back from the garage Then today, was cleaning the car and moved it, (haven't driven since and it was sat in the heat) check engine light back on, plugged black diagnostic plugs in and boom....Code 22 again! So I know it's not the sensor now? What's next to check? Cheers James.
May 13, 20169 yr Could be moisture underneath the sensor after being washed, Sent from my SM-G930F using Tapatalk
Create an account or sign in to comment