Jump to content

New to club and Scooby's


tiggrr1
 Share

Recommended Posts

Just to say hi to all and hope you don't mind a few questions in the coming days and weeks  :)

 

Just got my hands on a P1, number 22, with a few subtle mods and I'm already blown away by the fun it is to drive.

Picked it up on Thursday Jan 29th and so far very happy with it.

 

Modifications over the standard specifications are as follows:
SimTek ECU Upgrade yielding 335BHP 
AP Racing Big-Brake Upgrade with 330mm discs 
STI Type UK Version 8 'new-age' intercooler
RCM Cold air induction kit
HKS SSQV3 Blow-off Valve
Full stainless steel exhaust including downpipe (turbo-back) 
Exedy Race Clutch plus upgraded lightened flywheel 
550CC fuel injectors
Defi Gauges 
 
 
So far I have a few niggles to sort out (after all they are almost 15 years old).
 
1. OSR brake hose is a little tight from the shocker bracket to the caliper.
2. Headlamp washers don't seem to work. is ther a correct sequence or just push the button on the dash?
3. Boot floor wet but not rusty.
4. Rear washer pipe disconnected (don't think it's leaking into boot)
5. Exhaust turbo down pipe bracket not connected to gearbox at mounting bracket, though i have seen an advert saying that the new age down pipe fits but is not attached to the gearbox.
6. Fog lamp/Driving lamp cover screws seized in solid, any tips to get them out or is it a case of very carefully drilling the heads off the screws?
7. Front sidelights need drying out.
8. Small rub on OSF of front splitter, touch up paint needed.
 
I'm sure I'll find a few more bits and bobs as time goes by but I don't mind a bit of tinkering here and there ;)
 
scoobyp1_zps8bc739dd.jpg
  • Like 2
Link to comment
Share on other sites

Nice clean looking p1 you've found there with some choice mods and nice figures[emoji41]

I think the newage exhaust has two different mounting brackets one on the dowmpipe to gearbox and one on less on the backbox section .

you can get to the back of the fogs by disconnecting the indicator/fog wiring and removing the bumper but the nuts that the fog cover bolts go into are "captive" so unsure if bumper removal would help .

My headlight washers worked when lights were on and windscreen washer button (on the stalk) was depressed .

I disconnected mine anyways as my car is never that dirty and they kept stripping the wax off the bonnet.

Maybe look at some braided brake lines if you need to replace the standard ones

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share






×
×
  • Create New...




Forums


News


Membership


  • Insurance
  • Unread Content
  • Support