Everything posted by Phillip1993
-
What have you done to your Subaru today ?
Started to work on my mafless map today getting there slowly [emoji2]
-
Small issue that had me chortling
I think your lucky that noise happens at half the boost, I have to go everywhere twice the second time is so I can have some fun without her lol [emoji23]
-
Crazy fuel trims !!
Could do the fuel pressure reg getting week iv not seen it happen before but you never know, you would have to put a fuel pressure gauge on to find out
-
What have you done to your Subaru today ?
Well got my esl bord today and had a good 2 hours maping she is running good
-
Engine rebuild recommended oil????
I was aways told to use as cheap as possible for the first 500 miles preferably a mineral oil as modern oils are to slippery and don't alow the rings to cut the top off the peaks that the honeing leaves behind
-
Esl bord
Well iv got the bord now time to do some maping
-
Crazy fuel trims !!
It sounds and looks like The fual map table might be out towards the high load end but there are a lot of things that control fueling
-
Mapping
Ok I think I will stick to my td05 for now then, as I like the fact I will take more abuse
-
Mapping
So wot is better a td05 or a vf34
-
Mapping
Well the 1 I have on the car is the original and the car has only done 50,000 miles
-
Mapping
So I don't need to change that lol that's good to no
-
Mapping
Wot is the td05 good for
- Clutch
-
Clutch
Thinking about changing my clutch anyone got any ideas for a good 1
-
Heater not blowing cold
Have a look at the cables that come out the back of the control panel as it should be a direct link to the servo
-
Help with o2 sensor heater circuit please!!
From what I understand it goes to a pin on the ecu along with I a fue other sensors it could be where thay contact together before thay get to the ecu and i'm not sure where that would be on your car but if all is lost you could put your own ground in
-
Help with o2 sensor heater circuit please!!
It's most likely the ground that's at fult have you tryed test from the O2 sensor pos to a good ground like the battery
-
Heater not blowing cold
Yes it sounds like you have got a servo or a cable that has snapped depending on wot type of system it is but I have seen the dampers stick before to so try looking at that If it's the same as mine the servo that controls the hot cold is by the passengers feet if you look up from the floor
-
Subaru impreza gearbox
Ok I'm with you thanks for the help can't seem to find 1 much cheaper than £800 atm no worries will haft to keep an eye out for 1
-
Subaru impreza gearbox
How about this 1
-
Subaru impreza gearbox
http://m.ebay.co.uk/itm/SUBARU-IMPREZA-WRX-TURBO-GEARBOX-IMPORT-GC8-VER-2-STI-MANUAL-WARRANTY-ty752vb3fa-/172283404855?hash=item281ce42237%3Ag%3AY0wAAOSwwbdWMgeE&_trkparms=pageci%253A3d635153-5709-11e6-b63c-005056b688e4%257Cparentrq%253A407d97221560a2af5774a6c8fffb9575%257Ciid%253A1
-
Subaru impreza gearbox
Spot on that sounds good time to have a look on the bay
-
Subaru impreza gearbox
I'm probably going to be heading towards the 350bph limit on my impreza's gearbox and i'm wondering what would be a good replacement that's not the far to costly 6 speed sti gearbox
-
What have you done to your Subaru today ?
Ordered the esl bord, software and cable can't wait
-
Can someone explain what are these sensors and how to check if I have an EGR or not?
2 = is a change over value for the map to reed atmospheric pressure 3 = that's 1 of your ingetors 4 = the flat black box is the ignitor for the coil packs the round metal thing is your boost control solenoid 6 = 1 of your ingetors Don't no wot 5 is