Scooby Pete
Moderators
-
Joined
-
Last visited
Everything posted by Scooby Pete
-
Lol I sense a method to your madness, not many options left now -
-
-
-
I'm up for Japfest. Is the ticket per car or per person?z
-
Dukes of Hazzard
Alien Resurrection
Matrix revolutions.
Yep Gambit got it right.
It's a shame Lockwood have stopped doing replacement dials themselves? I had Lockwood silver dials in my classic and they changed the look completely. Less hassle and easier than swapping the cluster out.
There was a meet at the famous Ace cafe in honour of Paul. There is a tunnel run being organised by the Essex owners club. Basically a blat through Dartford tunnel with proceeds going to Paul's charity. And as gambit said the Santa Pod event.
The new STI looks a bit like this... An Evo X? ...will make its official debut at the 2014 Detroit Motor Show on the 14th January.
I like them and think the back end looks very similar to the hatch. Just a bit beefier. Wheels don't do anything for me any would be the 1st thing to go. Look to much like the wheels of a hot wheels car.
The first meet of 2014! As ever, it's at The Fairmile in Cobham. Full address for the pub is: The Fairmile Portsmouth Road Cobham Surrey KT11 1BW Kicks off from 13:00pm onwards! :thumb: As with the last couple of months, before adding your name to the list, please ensure that you read the following: Meet rules: 1. No idiotic driving on the roads surrounding the Fairmile 2. No damaging the Fairmile grass 3. No leaving litter/cans/pint glasses on the Fairmile grass 4. Do not partake in any other idiotic behaviour that gives Surrey Scoobies a bad name By putting your name in this thread you accept the above. In addition we ask that only Japanese cars park on the grass please. Members are more than welcome to come down in non-Jap cars (or bring friends) but please, Japanese only parked on the grass (there is a second car park to the rear of the Fairmile if you don't want to park in the main area). Cheers folks! :thumb:
Luigi where did you get them from? and do they do for 2008 models onwards?
Ah I'm with you now :D Never had the rigid type of flaps always had the rally type.
The rally flaps came with a metal bracket. If I remember rightly they fixed to a piece of the body work at the back inside corner of the wheel well. Your flaps look quite rigid, if you offer them up does the inside corner of the flap meet the body work anywhere? Have a look at this page. http://www.oakos.com/product_docs/RA-MF1.pdf There's is a pic near the bottom showing the fixing point for the inner rear wheel arch.
I had some rally mud flaps and the were fixed to the car through the 3 holes in the rear bumper. Seems logical that you would use the fixing points as well.
I used red pre mixed antifreeze , not sure on the amount you need though. Also forgot to mention when refilling the system make sure the cabin heater is on and set to max heat.
As far as I know there shouldn't be a rad cap. The filling is all done via the header tank. Sounds like it's got either a small pin hole leak or an air lock somewhere. Get it upto temp and check the rad for any leaks and the hoses for any leaks. These tend to only show when the system is upto pressure. If no leaks the drain the system and refill it same as if you replace the rad. My top tip is to refill the system is remove the top hose from the rad and fill the system up through the top hose. Also take the cap of the header tank. (It's easy to create air locks filling via the header tank) When you have filled the water upto the top of the top hose, start the car and wait for the thermostat to open (water will disappear from the top hose and should be now be pumped out the top of the rad). With engine running reconnect the top hose and top the system up via the header tank. Only fill the car with the recommended amount of coolant the header tank doesn't need to be full of water as it's really just an expansion tank and only fills up when the system in upto temp and under pressure. This should clear the airlock. Bear in mind when the thermostat opens the water will be hot! Having just mentioned the thermostat this could also be at fault, I had one that wasn't opening fully and was causing overheating issues. You can tell if the thermostat isn't working as the water will be not pumped around the engine and coming out the outlet at the top of the rad.
