stants
-
Posts
9,709 -
Joined
-
Last visited
-
Days Won
145
Content Type
Profiles
Forums
Events
Gallery
Store
Premium Membership Discounts
Subaru Videos
Subaru News
Everything posted by stants
-
March 2006 high tax bracket, can't see the n/a car being that different in what emissions it kicks out
-
ghetto photoshop!
-
If it's this side It's the middle pipe on the diagram savage posted up it goes to a denso module under the boost solinoid
-
Did you get any further with this ? If not these chaps have them.in stock, bit of a distance but you should be able to get control arms and all the other bits too http://www.scoobybits.co.uk/shop_parts.htm
-
Whats your audio set up in your Suburu
stants replied to Miker's topic in Subaru Audio / Electronics / Security
I'm only joking mate, I feel your pain, don't even look atvthe floor of the rear now just debris everywhere ! -
Whats your audio set up in your Suburu
stants replied to Miker's topic in Subaru Audio / Electronics / Security
Showing the hoover to the car wouldn't go amiss [emoji12] -
Paid for sunday
-
Haha can you not edit the length ? I set mine for 30min then if I need to I'll just chop it down with the phone software saves having dozens of files on the card
-
No worries, at a guess I'd say it probably has as I doubt they've changed the set up too much over the years I'll have a dig around see what I can find out
-
Whoop glad you've finally managed it without loosing any fingers, not heard of the company you mention, what year is your legacy ? I'm actually getting better mpg as it wasnt set up for UK fuel, normally the case was they tend to come out of the factory with a generic map, so now I'm set to run vpower and am getting alot better results, more hp and an extra 50ft lbs of torque to boot. The engine is no were near stressed and it probably runs better than it ever has
-
I have no idea mate, not even sure what set up the new ones run, do you have a pic of the engine bay you can post up ?
-
Right my engine is different my coils are in the centre, so maybe you have a v4/5? Based engine, I've chased the one that looks like it could be the same but it's a nightmare goes back towards the idle control valve housing then does a u turn under the manifold. In there somewhere ! If it's the other side it runs to the electrics going into the boost solinoid
-
Unless it's a nasty disease !
-
Lol red flaps ! I know your predicament I wasn't gonna go for red but the i/c I bought of sav had a red silicone hose attached, sort of sealed the deal for me then
-
No worries give me an hour and I'll go take some pics for you
-
Don't loose the restrictor pill from the lines near the turbo or you be stuffed !
-
If all else fails I can chase mine back for you ?
-
I'd maybe get a couple of meters of each diameter, 3mm for turbo vac and some of the smaller stuff running off the inlet 5mm for other bits and possibly the bigger hose for anything else,
-
How much do you want to do ? If I remember correctly 3mm internal diameter about six foot should do it and leave you a but to use else where if needed
-
Oof ! Have you looked at heywood & Scott ?
-
The perrin stuff is well made and competitively priced but we get stung on shipping and tax. Scooby clinic sell the stuff over here. With regards to the remap you pay for the licence map and dyno time so 550 isn't that bad any subsequent remaps won't cost as much as you already have the licence
-
Classic arb to chassis mounts
stants replied to stants's topic in Subaru Tyres / Wheels & Suspension
Haha no worries mate weather's been terrible here too, I'll post a pick up of mine you may be able to confirm just by looking. People on the foz site say it should be ok and will probably fail at some point in the future, I can't be arsed fitting it only to have to replace a part in the future, may as well do a job properly the 1st time Thanks again Clive -
Cos worth are good as don't interfere with the maf but the need changing every x amount of miles. If you got a sports cat system should keep you legal and be better flowing
-
To be honest you'd probably get the power gains your after with just air filter, exhaust and map.
-
Can someone measure the drop on the mounts for me please? I took pictures on Monday of the classic mount but no measurements. Been having a poke around mine and the foz's appear to be longer to accommodate the extra ride hight so I may have to get new mounts as don't want to end up twisting them
